How to Perform Lorex Camera Reset Process?
There is a simple and quick solution to reset Lorex Camera to factory default if you have forgotten or misplaced the password. Bringing the Lorex camera to factory default implies that you can resolve various issues and errors that the camera is experiencing.
By pushing the reset button on the motherboard, users of these Lorex Wi-Fi cameras can perform a reset or factory reset. On some IP cameras, there is a reset button. The camera’s default settings will be reinstated after a manual reset.
In order to reset Lorex camera:
- Firstly, ensure that the camera is connected to the NVR through an Ethernet wire.
- After that, reset the camera by pressing and holding the Reset button on the back or base.
- Then, you may need to remove the housing to access the Reset button. To find where the Reset button is on your specific model, see the user manual for your camera.
- Reset button on a bullet camera
- Then, disconnect and re-connect the Ethernet wire while continuing to hold down the Reset button.
- After that, hold the button down for another 15 seconds before letting go.
- It will take a few minutes to resume after we reset Lorex camera
- Then, your camera should resume regular operation after restarting, but you will need to adjust your system and recording settings.
Factory Restore Lorex Camera
In order to factory reset lorex camera, you might follow the following steps depending on your model.
Resetting these Lorex camera models allows:
- Series W261AQ (1080p Full HD Smart Indoor Wi-Fi Pan-Tilt Security Camera)
- Series W261AS (1080p Full HD Smart Indoor Wi-Fi Security Camera)
- Series: W281AA (Smart Outdoor WiFi Security Camera With Advanced Active Deterrence)
How to reset W261AQ Lorex cameras?
Follow these steps to restore the Lorex W261AQ camera to its factory settings:
- Initially, search for the reset button. The reset button for the W261AQ Series is situated beneath the lens.
- After that, turn the lens all the way up to locate the reset button. To prevent harming the PTZ motor, make sure the camera is unplugged. reset lorex wi-fi camera
- To reset the camera, depress and hold the reset button for 10 seconds until the chime plays.
- To tell if the camera has been completely reset, look for a green light that flashes below the lens. A firm or constant green light, however, signifies that the camera has not been completely reset. Then, you may have to redo the process again.
resetting W261AS Cam made by Lorex
Follow these procedures to restore the Lorex W261AS camera to its factory settings:
- Search for the reset button. The reset button for the W261AS Series is found on the camera’s back.
- Reset the camera, depress and hold the reset button for 10 seconds until the chime plays.
- To tell if the camera has been completely reset, look for a green light that flashes below the lens.
- The camera has not been fully reset if the green light is solid or constant. You may have to redo the process again.
restore W281AA Lorex cameras
Follow these procedures to restore the Lorex W281AA camera to its factory settings:
- Firstly, search for the reset button. The reset button for the W281AA Series is found at the top of the camera.
- To reset the camera, depress and hold the reset button for 10 seconds until the chime plays.
- the Lorex wi-fi camera reset
- To tell if the camera has been completely reset, look for a green light that flashes below the lens. The camera has not been fully reset if the green light is solid or constant. Then, you might need to repeat the procedure.
This is how to reset Lorex Camera, for further information with Lorex camera setup contact us.